Rubber Powered Dart Launcher & Darts


Introduction:

Rubber Powered Dart Launcher & Darts

In this Comment/How-to I will try to show how to make a top little rubber powered dart launcher and darts.

The gun is based on the glove gun I made in an earlier Comment/How-to, but this is designed specifically for darts or little arrows and does not require the finger of a rubber glove - just a strip of rubber as you will see.

Step 1:

What you will need

  1. This the wrist part of a rubber glove.
For the Launcher:
  • A length of plastic pipe about 400mm long. Half inch pipe is fine.
  • A strip of rubber from a rubber glove or similar. 200mm x 20mm approximately.
  • Duct Tape.
For the Darts:
  • Bamboo barbecue sticks. Available from any supermarket.
  • Duct Tape
Tools:
  • Hacksaw to cut the pipe.
  • Scissors.

Step 2:

Make your Launcher

Simply tape the strip of rubber to one end of the pipe as shown in the pictures. Use enough duct tape so the rubber won't pull out when you pull back on it.
Your launcher is now ready. Just need some darts.

Step 3:

Make some darts

Just back from the sharp end of the dart wrap a strip of duct tape about 20mm x 100mm around the bamboo stick. This will give the dart some weight at the front.

To make the flights use duct tape. Leaving enough length of shaft to grip with your fingers, wrap the tape around the stick and make three folds as in the pictures. With scissors trim the flights to the desired shape. They will need to be small enough to pass through the pipe of the launcher.

Repeat this process until you have enough darts.

Step 4:

Shooting

Before going any further please consider the safety of yourself and those around you. This thing could be a bit dangerous. If it were to hit someone in the eye they could possibly be blinded so please take care.

To fire the dart gun just:
  • insert the dart into the breech,
  • put the rubber over the end of the dart,
  • grip the dart through the rubber,
  • pull back, *** DO NOT pull back so far that the dart comes out of the gun completely unless you want to punch it through your other hand.
  • Aim at your target,
  • release.
Here's a quick video to demonstrate...


Step 5:

Variations on the gun

  1. http://www.instructables.com/id/Toy-Ingram-M6-Glove-Gun-2/
  2. http://www.instructables.com/id/How-to-make-a-Double-Barrel-Glove-Gun/
Variations of this simple design are only limited by your imagination.

I hope you can have some fun with it.



Comments

Add a Comment

Sign in to comment.