Wall Led Lamp


Introduction:

Wall Led Lamp

This lamp is constitued by two aluminium C shaped channels with a led strip lamp inside.
I hanged it on the wall, using two hooks that were fixed by former inhabitants.


Step 1:

Piercing the Aluminium Channel

I drilled two holes to hang the lamp on the hooks.

Step 2:

Cutting C Shaped Spacers

I was planning to glue the two channels back to back but my led strip wasn't flexible enough.

I decided to cut some pieces of the channels as spacers. Their length is equal to the width of the channel (more or less, I'm not very precise with a saw).

Step 3:

Glueing the Channels

I used epoxi glue to fix the parts together. It was my first test of this kind of glue and I wouldn't choose that option again. It's not as strong I believed. Small screw and nuts Would be better I guess.

Step 4:

Glueing (or Not) the Led Strip

Same disapointment with the glue and the led strip. It didn't worked very well.

I drill holes on the back side of the lamp and sticked wooden picks to hold the strip in place as a backup solution.

Step 5:

Mehr Licht

Here's the result. The cable is hidden behind the curtain.

The room was lacking light on this side and I wanted indirect lighting.

This project could be simpler without the use of epoxi glue.




Comments

Add a Comment

Sign in to comment.